Stanford team sends wireless data using thermal noise


Researchers used an insulated chamber to transmit information without an actively generated radio signal. They plan to test the system in noisier settings and with multiple transmitters.
Stanford University researchers have sent wireless data using thermal noise instead of an actively generated radio signal. Their transmitter and receiver were inside an insulated chamber that shielded the weak signal from other noise, Physics World said. The team sees potential for low-power links in places where radio signals can interfere with sensitive equipment.
The work builds on an experiment published in Proceedings of the National Academy of Sciences in 2022 by Zerina Kapetanovic and University of Washington colleagues. They sent information using thermal noise without a generated or ambient radio-frequency source by selectively connecting and disconnecting an unpowered resistor to an antenna, but Kapetanovic wondered how the receiver could distinguish noise patterns when the system was at room temperature.
Thermal noise comes from the random movement of charged particles in a conductor at temperatures above absolute zero. Rather than generate a radio signal to carry data, the Stanford transmitter switched its antenna between an open circuit, representing 1, and a short circuit, representing 0. The receiver amplified noise reflected by the antenna and read those bits, the basic units of digital information.
The researchers found that the two states made the reflected noise appear hotter or colder to the receiver, even though there was no actual temperature difference. Stanford describes the receiver’s amplifier as acting like an electron refrigerator, making thermal noise appear colder; the transmitter switches between absorbing and reflecting it.
The team also built a channel model, an equation describing the variables that govern the wireless link. Using it to adjust the setup increased the data transfer rate by a factor of 100 compared with the earlier setup.
The study appeared in Proceedings of the National Academy of Sciences. Stanford graduate students Geneva Ecola and Jida Zhang were co-first authors; electrical engineering assistant professor Kapetanovic was the senior author, and electrical engineering professor Joseph Kahn was also on the team.
The team sees possible uses near radio astronomy observatories and hospital equipment sensitive to electromagnetic radiation, where an active signal can cause interference. Ecola estimated that a radio-frequency transmitter uses up to 1,000 times as much energy to send information as a transmitter using only thermal noise, a comparison of the transmitters rather than the entire links.
So far, our evaluation has been limited to a controlled environment with minimal external interference,
The researchers plan to test whether the system can send data in noisier conditions and to link multiple transmitters in a network.
Anutin Charnvirakul ordered alternative supplies and close monitoring after water was suspended to 14 villages where arsenic at the local waterworks reached 30 times the safe limit.
3 min

Lawmakers voted 53 in favor, with none against and 29 abstentions. The bill would extend coverage to around 350,000 lower-paid employees, but it still needs a second reading and full approval to become law.
2 min

Joe McCrisken’s inquiry concluded that Ballymacombs More Woman was killed more than 2,000 years ago, when she was between 15 and 22 years old.
2 min